The times have made it impossible to keep up with all the clutter we seem to collect. Even when you clean there is still clutter around, which still makes it look messy. The computer is buried under paperwork, research material, and reference books. The closet swallowed the new outfit you just bought. Finding anything has become a search and rescue mission. It is time to build a closet organizer.
It is not as hard as it sounds. There are certain steps you must take. Do them in the order listed and you are on your way to a clutter free space. Take a deep breath and get motivated.
The first thing you must do is get the dimensions of the chosen closet. This means each wall, the height, and depth. You will want to know how much room you have to work with. Draw it out on graph paper to get the dimensions to scale.
The simplest closet organizer to build is a unit with two tiers for hanging clothes, a couple shelves, and maybe some storage bins. You will want to go from the door to the back wall in a deep closet. For the shallow coat closets you need to go from side to side. The same design can actually be used for both.
Once you have a design plan, you need to buy the material. Remember when figuring linear board feet you should add 10% for cuts. It is smart to buy a board or two extra just for those times you cut a board too short. If you need help deciding how much material you need, ask the service desk for help. This is what they are there for.
You will need shelf supports along the wall to hang your shelves from. These should be 84" from the floor in a closet with an 8 foot ceiling. This will give you ample space to store things on the top shelf. Be sure to uses drywall anchors to install these boards. You do not want this unit pulling out of the all. Measuring down from the first set of supports, install the second set if you want another shelf. A good guide would be 8 to 12 inches down from the first.
A central shelving unit can be formed by measuring from the bottom of the last shelve to the floor. Cut two side panels the appropriate length. In this case of two shelves the measurement should be 72" to 76". It is always advisable to measure twice and cut once. After you cut the sides check for fit. If they are too long, trim off the excess. Be careful not to take too much off. You will want to cut four boards to use as the center shelves. These should be 1 foot in length. Screw the sides to the center shelved using 2 1/2" wood screws. Nails tend to loosen after time. Wood screws will hold the shelves secure. Place the center shelving unit where you want it to be. Because this is a free standing system you do not have to anchor it to the wall.
You will need to buy hardware to hang the dowels. You will need 6 brackets for the dowels to hang from. Remember you will want clearance for the hanger. The brackets should be placed 2 to 3 inches below the lower shelf. This will be for the upper dowels. The lower dowel brackets need to be 38" above the floor. Slip your dowel rods in.
That is all there is to it. You now know how to build a closet organizer. Once it is done the closet will look clean and clutter free.
Not sure which closet organizer is the right one for your closet? No problem, explore inexpensive closet organizers by visiting http://www.bestclosetorganizerguide.com a popular closet organizing site that provides tips, advice and resources on organizing small closets that always seem to have stuff thrown into them.
Article Source: http://EzineArticles.com/?expert=Mark_Clifton
RSS Feed (xml)
No comments:
Post a Comment